Using The Test Input Function - Panasonic SF4С Series Instruction Manual

Operation

4.2 Using the Test Input Function

The safety light curtain incorporates the test input function. With this function you can simulate
the status when the beam is blocked.
Indicator symbol
Setting procedure
1 Before the power
is on connect the
test input to Vs
(Note 1)
2 After the power is
on the control
output (OSSD
1/2) of the
receiver is on
(normal
operation).
(Note 2)
3 Open the test
input/reset input
to switch the
receiver's control
output (OSSD
1/2) to off.
(Note 3)
4 Connect the test
input/reset input
to Vs (Note 1) to
switch the
receivers control
output back to on
(normal
operation).
(Note 2)
NOTE
1. Vs is the applied supply voltage.
90
SEN TRONIC
AG
Produkte, Support und Service
Explanation
Lights up red
Lights up orange
Lights up green
Turns off
Emitter
Rugghölzli 2
CH - 5453 Busslingen
SF4C Safety light curtain
Indicators
Receiver
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
Control
output
(OSSD 1,
OSSD 2)
OFF
ON
OFF
ON
mailbox@sentronic.com
www.sentronic.com