Port Forwarding Edit Screen - ZyXEL Communications LTE3301 Series User Manual

Table 37 Network > NAT > Port Forwarding (continued)
L ABEL
Service Protocol
WAN Interface
Port Range
Translation Port
Range
Server IP Address
#
Status
Name
Protocol
WAN Interface
Port
Port
Translation Port
Server IP Address
Modify
Apply
Cancel
10.3.1 Po rt Fo rwa rding Edit Sc re e n
This screen lets you edit a port forwarding rule. Click a rule's
open the following screen.
Chapter 10 NAT
DESC RIPT IO N
Select the transport layer protocol supported by this virtual server. Choices are
.
T C P_UDP
If you have chosen a pre-defined service in the
configured automatically.
Select the WAN interface on which the matched packets are received.
Specify the first and last external port numbers that identify the service.
If you have chosen a pre-defined service in the
be configured automatically.
Specify the first and last internal port numbers that identify the service.
If you have chosen a pre-defined service in the
be configured automatically.
Enter the inside IP address of the virtual server here and click
forwarding summary table.
This is the number of an individual port forwarding server entry.
This icon is turned on when the rule is enabled.
This field displays a name to identify this rule.
This is the transport layer protocol used for the service.
This field displays the WAN interface on which the matched packets are received.
This field displays the port number(s).
This field displays the external port number(s) that identifies the service.
This field displays the internal port number(s) that identifies the service.
This field displays the inside IP address of the server.
Click the icon to open the edit screen where you can modify an existing rule.
Edit
Click the icon to remove a rule.
De le te
Click to save your changes back to the LTE3301.
Apply
Click to begin configuring this screen afresh.
C a nc e l
LTE3301 Series User's Guide
90
field, the protocol will be
Se rvic e Na m e
field, the port number(s) will
Se rvic e Na m e
field, the port number(s) will
Se rvic e Na m e
to add it in the port
Add
icon in the
Edit Po rt Fo rwa rding
, , or
T C P UDP
screen to