ZyXEL Communications LTE3301 Series User Manual page 79

Network > Wireless LAN > WDS
Fig ure 47
The following table describes the labels in this screen.
Table 31 Network > Wireless LAN > WDS
L ABEL DESC RIPT IO N
WDS Setup
Basic Setting Select
Select
Select
Local MAC Address This shows the MAC address of the LTE3301.
Phy Mode Select the physical mode supported by the LTE3301.
You must also set the peer device to use the same physical mode.
Remote MAC Type the MAC address of the peer device in a valid MAC address format, that is, six
Address hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Security
Encryp Type Select the type of security you want to use (
Otherwise, select
Select
is compatible with other ZyXEL access points that support WDS security. Use this if the other
access points on your network support WDS security but do not have an AES option.
AES provides superior security to TKIP. Use
support it for the WDS.
Encryp Key Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including spaces and
symbols).
You must also set the peer device to use the same pre-shared key.
Apply Click
Reset Click
Chapter 7 Wireless LAN
to turn off the WDS function on the LTE3301.
Disa b le
to have the LTE3301 function as a bridge and access point simultaneously.
AP+Bridg e
to have the LTE3301 act as a wireless bridge only.
Bridg e O nly
.
No Se c urity
to enable Temporal Key Integrity Protocol (TKIP) security on your WDS. This option
T KIP
to save your changes back to the LTE3301.
Apply
to reload the previous configuration for this screen.
Re se t
LTE3301 Series User's Guide
79
or ) to secure traffic on your WDS.
T KIP AES
if the other access points on your network
AES