Graco Reactor H-40 Operation page 29

Startup
A
g. Turn on
pressing
h. Hold to view electrical currents for
each zone.
i. Hold to view heater control circuit
board temperature.
j. Manual current control mode only:
When in manual current control mode, moni-
tor hose temperature with thermometer.
Install per instructions below. Thermometer
reading must not exceed 160°F (71°C).
Never leave machine unattended when in
manual current control mode.
If FTS is disconnected or display shows
diagnostic code E04, turn main power
switch OFF
clear diagnostic code and enter manual
current control mode.
show current to hose. Current is not lim-
ited by target temperature.
To prevent overheating, install hose
thermometer close to gun end, within
operator view. Insert thermometer
through foam cover of A component
hose so stem is next to inner tube. Ther-
mometer reading will be about 20°F
less than actual fluid temperature.
B
and heat zones by
for each zone.
then ON
display will
If thermometer reading exceeds 160°F
(71°C), reduce current with
3. Set pressure
Motor Controls and Indicators, see
a. Press
reading.
b. Press motor
start. Display shows system pressure.
to
Motor must rotate counterclockwise
when viewed from shaft end. See Con-
nect electrical cord, page 22.
ON / OFF
PARK
PSI
BAR
page 19
to display the pressure
. Motor and pumps
29
key.