Graco Reactor H-40 Operation page 9

Hydraulic, heated, plural component proportioner for spraying polyurethane foam and polyurea coatings, not for use in explosive atmospheres
Hide thumbs Also See for Reactor H-40:
Table of Contents

Advertisement

Warnings
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
This equipment is for professional use only.
Do not leave the work are while the equipment is energized or under pressure. Turn off all
equipment and follow the Pressure Relief Procedure in this manual when the equipment
is not in use.
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical Data in all equipment manuals.
Use fluids and solvents that are compatible with equipment wetted parts. See Technical
Data in all equipment manuals. Read fluid and solvent manufacturer's warnings. For com-
plete information about your material, request MSDS forms from distributor or retailer.
Check equipment daily. Repair or replace worn or damaged parts immediately with genu-
ine manufacturer's replacement parts only.
Do not alter or modify equipment.
Use equipment only for its intended purpose. Call your distributor for information.
Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot sur-
faces.
Do not kink or over bend hoses or use hoses to pull equipment.
Keep children and animals away from work area.
Comply with all applicable safety regulations.
MOVING PARTS HAZARD
Moving parts can pinch or amputate fingers and other body parts.
Keep clear of moving parts.
Do not operate equipment with protective guards or covers removed.
Pressurized equipment can start without warning. Before checking, moving, or servicing
equipment, follow the Pressure Relief Procedure in this manual. Disconnect power or
air supply.
BURN HAZARD
Equipment surfaces and fluid that's heated can become very hot during operation. To avoid
severe burns, do not touch hot fluid or equipment. Wait until equipment/fluid has cooled com-
pletely.
WARNING
9

Advertisement

Table of Contents
loading

Table of Contents