Advertisement
Refer Joey re chart image
1. Press UP (+) or DOWN (-) arrows to change the DURATION
2. Press the STEP 1 key again to change the SPEED setting.
The SPEED setting LED will illuminate. The bar graph will show default SPEED for
STEP 1.
3. Press UP (+) or DOWN (-) arrows to change the SPEED.
4. Press any STEP or OVERRIDE key to save the DURATION and SPEED settings
for STEP 1. If the user decides not to save the settings, pressing the STOP key will
revert back to the previously stored setting.
5. Press STEP 2, STEP 3, or OVERRIDE key. Repeat steps 1- 4 to program the
corresponding DURATION and SPEED for each button.
6. Press START to run the Waterco ECO-V 150 based on the programmed 24 hour
schedule.
7. Pressing the STOP button will stop the Waterco ECO-V 150.
Note: The Waterco ECO-V 150 can only be set to operate on a 24-hour schedule. If
a user attempts to program a schedule with a combined duration for all three steps
greater than 24 hours, the Waterco ECO-V 150 software will retain the current STEP
time duration only, and will zero out the other two STEP time settings. As an
example, if STEP 1 equals eight (8) hours, STEP 2 equals nine (9) hours, and STEP
3 equals eight (8) hours – for a combined 25 hours – the Waterco ECO-V 150 will
retain the setting for the current Step being programed and zero out the remaining
two. For details regarding the set-up of the three steps as part of a 24-hour schedule,
see section 6.
Hide quick links:
Advertisement
