Advertisement
Quick Start Instruction
If power is connected to the Waterco ECO-V 150 motor, pressing any of the
following buttons referred to in section 3 could result in the motor starting. Failure to
recognize this could result in personal injury or damage to equipment.
The following table describes the factory default settings for DURATION and SPEED
order:
Refer Joey re chart image
Pressing the START key will start the Waterco ECO-V 150 based on the factory
default schedule.
Note: If power is cycled to the Waterco ECO-V 150 and the user does not press the
STOP key, the Waterco ECO-V 150 will automatically start and run the
programmed default schedule shown in the chart above. This feature ensures that
the Waterco ECO-V 150 will re-start in the event of a power outage.
3.2 Quick Start Guide (User-defined custom schedule)
A Waterco ECO-V 150 user can set the program DURATION and SPEED for
STEP 1, STEP 2, STEP 3 & OVERRIDE keys.
Note: Waterco ECO-V 150 must be Stopped (Press STOP Key) for programming
DURATION and SPEED of the STEP 1, STEP 2, and STEP 3 keys. OVERRIDE
DURATION and SPEED can be programmed when the Waterco ECO-V 150 is
either stopped or running.
Press the STEP 1 key. The STEP 1 button and DURATION setting LEDs will
illuminate. The bar graph will show default DURATION for STEP 1.
Hide quick links:
Advertisement
