Advertisement
WARNINGS FOR INSTALLATION AND ASSEMBLY TASKS
1. When connecting electric cables to the motor of the pump, be careful to correctly
arrange them inside the connection box, verify that no bits of cable are left inside the
box on closing it. See that the earth wire is correctly connected. When connecting
the motor, follow the wiring diagram supplied with the pump.
2. Be especially careful that no water enters the motor or electrical parts under
voltage.
3. In the event that the planned use is not as specified, adaptations and
supplementary technical rules may be necessary.
• WARNINGS FOR START UP
Before starting the pump, verify the calibration of the electrical protection devices of
the motor and that the protections against electrical and mechanical contacts are
correctly positioned and attached.
FLUID TEMPERATURE
O
O
O
O
The permissible temperature is > than 32
F (0
C) and < than 95
F (35
C). The
pump should never be operated outside of these temperatures or damage may
occur.
WARNINGS FOR ASSEMBLY AND MAINTENANCE TASKS
1. Be especially careful that no water enters the motor or the electrical parts under
voltage.
2. Avoid all contact, even accidental, with the moving parts of the pump.
3. Wait until the pump has stopped completely before handling it in any way.
4. Before carrying out electrical or mechanical maintenance tasks, make sure that
the machine has been disconnected from the mains and that starting devices have
been locked.
5. It is advisable to follow the steps listed below before handling the pump in any
way.
a) Turn off the voltage to the pump.
b) Lock starting devices.
c) Verify that there is no voltage in the circuits, including ancillary devices and
auxiliary circuits.
d) Wait until motor stops completely.
The above list should be considered indicative and not binding for the purpose of
safety; specific safety rules may exist in particular regulations.
Hide quick links:
Advertisement
