Waterco ECO-V 150 Owners & Installation Manual page 5

13. The appliance is not intended for use by young children. Young children should
be supervised to ensure that they do not play with the appliance.
The Waterco ECO-V 150 is for use with 208-230 Vrms nominal, and in pool pump
applications ONLY. Connection to the wrong voltage, or use in other application may
cause damage to equipment or personal injury.
The integrated electronics interface controls the speed settings as well as the run
durations. The Waterco ECO-V 150 can run at speeds ranging between 600 and
3450 RPM and is rated for 208-230 Vrms at an input frequency of 60 Hz.
Navigation Overview
 +, - Increases/decreases selected value
 Pressing any key following a change accepts the current value displayed inside
the setting
Refer Joey re panel image
Figure 1: Waterco ECO-V 150 User Interface Button Descriptions
CAUTION
If power is connected to the Waterco ECO-V 150 motor, pressing any of the
following buttons referred to in section 2 could result in the motor starting. Failure to
recognize this could result in personal injury or damage to equipment.
Note: The START button must be pressed for the Waterco ECO-V 150 to operate.
The START LED will illuminate after the button has been pressed indicating the
Waterco ECO-V 150 is capable of operating. Pressing the stop button will turn off the
START LED and stop the motor if running.