Advertisement
DURATION and SPEED setting LEDs along with its respective bar graph LED will
blink back and forth at three (3) second intervals.
2. The UP (+) / DOWN (-) arrows allow the user to configure OVERRIDE DURATION
and SPEED. These settings can be changed while the Waterco ECO-V 150 is
running. These settings are stored each time the UP (+) / DOWN (-) arrows are
pressed.
Refer Joey re chart image
NOTE: When the OVERRIDE duration ends, the Waterco ECO-V 150 resumes the
24 hour schedule at the point in the currently programmed 24 hour schedule where it
normally would be running at that time.
The OVER-RIDE duration will not affect the start or stop times of the 24 hour
schedule. For example, if OVERRIDE runs during a period overlapping with a later
part of STEP 1 and an early part of STEP 2, the start time of STEP 3 is not affected.
Note: Pressing/Holding OVERRIDE key for more than three (3) seconds will cancel
OVERRIDE mode.
Note: During the OVERRIDE mode, the Waterco ECO-V 150 will not start with the
priming sequence.
Note: It is recommended that you do not set the OVERRIDE duration to 0 HRS.
Setting the OVERRIDE duration to 0 HRS will not allow you to change the duration
setting while the motor is running. The motor will have to be stopped in order to
change the OVERRIDE settings if the duration is set to 0 HRS.
Hide quick links:
Advertisement
