Advertisement
4. This sequence will then repeat for STEP 2 and then STEP 3 without the Waterco
ECO-V 150 stopping.
5. At the end of STEP 3, the Waterco ECO-V 150 will wait if necessary for the
completion of the 24-hour schedule. During this waiting period (if applicable), all of
the "active step LEDs" will remain OFF.
However, the START LED will still be illuminated. After completion of the 24 hour
schedule, the system restarts at STEP 1 and this cycle will repeat indefinitely until
the user presses the STOP key.
Note: Pressing a STEP key other than for the STEP currently running will cause an
immediate transition to the newly selected STEP. The Waterco ECO-V 150 will
continue with the programmed schedule from that point forward.
Note: If STOP is pressed during normal schedule operation, the 24 hour schedule
will stop. When START is pressed again, the 24 hour schedule will start from STEP
1.
Note: If power is lost while the Waterco ECO-V 150 is running a 24 hour schedule,
upon restoration of power the Waterco ECO-V 150 will start the 24 hour schedule
from STEP 1.
Note: If a digital input (provided from an external source) is detected, the Waterco
ECO-V 150 will start running on the STEP 1, STEP 2, STEP 3, or OVERRIDE speed
corresponding to the digital input. Upon removing the digital input (provided from an
external source), the Waterco ECO-V 150 will stop and the user will need to press
START to begin the 24 hour schedule operation.
However, if START was already pressed prior to receiving a digital input, then the
Waterco ECO-V 150 will resume running the 24 hour schedule once the digital input
is removed.
NOTE: Pressing STOP at any time turns the Waterco ECO-V 150 OFF and clears
the start time for the 24 hour schedule.
6.5 OVERRIDE
The Waterco ECO-V 150 is equipped with an OVERRIDE feature, which can be
engaged to temporarily run at higher or lower speeds ranging between 600 to 3450
RPM. Once the OVERRIDE duration has elapsed, the Waterco ECO-V 150 will
automatically return to the programmed schedule.
1. Pressing the OVERRIDE key while the Waterco ECO-V 150 is running will cause
the Waterco ECO-V 150 to start running in the OVERRIDE mode at the programmed
DURATION and SPEED. The "active LED" for OVERRIDE will illuminate. The
Hide quick links:
Advertisement
