Adjusting Dual Stacker Tray Scuffer Arms - Xerox DocuPrint 4090 IPS Troubleshooting Manual

Adjusting dual stacker tray scuffer arms

Troubleshooting Guide
5. Remove only the set of pages leaving the stitcher/stacker at
the right, and place it on the output in the stacker tray. Do not
remove any other pages from this area.
NOTE: The pages were compiled by the stitcher/stacker into
a set (stapled or not), but something prevented the set from
being delivered to the stacker. You put the set in the stacker
tray because the system has counted it as completed.
6. Close the side and top covers.
7. Press the Continue button to resume printing.
Paper jams can occur when the paper does not stack smoothly
in the stacker trays. If some papers stack well while others do
not, the scuffer arms may need to be adjusted.
NOTE: The scuffer arm weights on some printers are bolted in
place. These must be adjusted by a service representative.
The adjustable weights are located on the underside of the
scuffer arms, on a track down the center. To adjust them:
1. Slide the weight right or left along its track under the scuffer
arm.
• If the paper is driven too far up the outside edge of the
tray, move the weight toward the machine.
• If the paper is not driven far enough into the tray, move the
weight away from the machine.
NOTE: For lightweight paper move the weight toward the
machine; for heavyweight paper, move the weight away
from the machine.
Clearing paper misfeeds and jams
4-27