Manual Duplex Printing - Xerox DocuColor 45054549 User Addendum

Manual duplex
printing
T
Manual duplex printing using Tray 5 (Bypass) or Tray 6 (Oversized)
Manual duplex printing is supported using either Tray 5 (Bypass) or Tray 6 (Oversized) as the
paper source. You can print duplex output in a fully manual mode, determining the required
paper manipulation yourself, or you can print in a semi-manual mode, in which the
Fiery EXP250 prompts you to perform the manual steps required.
O PRINT IN A FULLY MANUAL MODE
1 Print two jobs: the first containing the even-numbered (Side 2) pages, and the second
containing the odd-numbered (Side 1) pages.
Since the jobs are separate, you can even print from different applications if desired. Or you
can print from one document, but print even-numbered pages as one job and odd-numbered
pages as one job.
2 For the first job, set the print options as follows:
• Face-Down Printing = Face Up
• Paper Source = Tray 5 (Bypass) or Tray 6 (Oversized)
• Page Size and Media Type = type of media loaded in the Paper Source
3 Print the first job.
4 Notice how the pages are oriented in the output tray before removing them.
5 Turn the pages over so that the printed side faces down and load them back in the same tray
used to print the first job.
Depending on how you flip the pages, you can print Side 1 with the same orientation as
Side 2 (Top-Top) or rotated 180 degrees relative to Side 2 (Top-Bottom). The illustration
below shows the output for Top-Top and Top-Bottom for both Portrait and Landscape jobs.
Portrait
Landscape
For Top-Top printing, keep the pages oriented the same way as they were in the output tray,
except face down. For example, if the pages are upside down and face up, load them upside
down and face down.
Top-Top
1 2
1 2
Page
Top-Bottom
2
1
2
1
16