Installation Instruction; Set Up; Preparation Before Starting The Display; Start And Entry Setting - King-Meter J-LCD Manual

4 Installation Instruction

Fix the display and 30 button on the handlebar and adjust
to an appropriate visual angle.

5 Set up

5.1 Preparation before Starting the Display

Make sure connector linked properly to the motor
controller on the bike.

5.2 Start and Entry Setting

Press the MODE button and start the display.
After start-up, please hold both UP and DOWN at the
same time, for 3 seconds, LCD will enter into the setting
state.

5.3 Time Set up

After entering into the setting state, first set the HOUR by
using UP and DOWN. Press MODE for confirmation
and then set the MINUTE by UP and DOWN. Press for
Confirm by MODE then move to set up the max speed.
Setting HOUR Setting MINUTE
22