Perform A Test Scan; Adding And Calibrating A Printer - Xerox XEScan Installation Manual

15. Close the Diagnostic application if it is still open.
16. Power off and power on the scanner.
17. If purchased, redeem and install the Feature Keys. Refer to the XES Feature Key Instructions included
in the Feature Key Kit

7. Perform a Test Scan

To scan a document, perform the following steps.
1. Double mouse click on the XEScan icon. The Keycode Entry window appears.
2. Click the Scan Target button and load the Keycode Print into the scanner, printed side down and printed
arrow toward the scanner. Alternatively, enter the Keycode printed on the Keycode Print into the dialog.
Click OK.
3. The XEScan application starts.
Note: If you click Cancel at the Keycode Entry Screen, the keycode may be entered later in the
XEScan application by clicking on the Info pulldown menu. Select Keycode Entry. Click the Scan
Target button and insert the Keycode Print into the scanner. Or enter the Keycode printed on the
Keycode Print. Click OK.
4. The Hardware Configuration window opens. Select the Synergix Scanner.
5. Insert the Keycode Print face down into the scanner.
6. Select Preview. The scanner transports the print and the page appears in the XEScan preview window.
This verifies that the system operates correctly.
7. Go to the Synergix XEScan Customer Training Guide to learn more about scanning documents.

8. Adding and Calibrating a Printer

The XEScan Reflection and Reflection Plus software packages add Scan-to-Print functionality to the
XEScan Solution system. In order to copy documents or print files, the target printer or printers must be
installed in the XEScan software. The software package and number of licenses purchased by the customer
determine the number of printers you can install.
As a prerequisite to these steps, the target printer(s) must be installed and functioning. If necessary, the
printer(s) should be calibrated to produce the best possible output.
1. Double-click the XEScan icon to open the application.
2. Select [File:Copy Mode] to enter the Reflection copy interface screen.
3. Select [Configuration:Hardware] to enter the Hardware dialog screen.
4. Select the printer to be installed from the list of Available Printers on the left side column.
5. Click the arrow button between the columns to move the printer into the Installed Printers column.
6. Click the hardware dialog button at the bottom of the Installed Printers list. This will invoke the printer
configuration dialog.
XEScan Solution Installation Guide 13