Low Battery Indication - Youshiko YC9330 User Manual

8.3 Daily Alarm Function:
Press " MODE/SET" button (B2) to select to view:

Time Time & Day of Week Alarm Time ( "AL" shown on the LCD)
When viewing the Alarm Time, hold "MODE" button (B2) for 3 seconds to enter

Alarm Time setting. Press "+" (B4) or "- "(B5) button to adjust the alarm time.
Press "MODE" button (B2) to confirm the setting.
Press "AL ON/OFF" button (B4) to switch alarm on or off. If it is on, "

on the LCD.
When Alarming, alarm icon "

the snooze alarm, ("
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times.
Except "SNOOZE" button, press any buttons to stop the snooze alarm. Otherwise,

the alarm signal sounds for about 2 minutes, and then stops automatically.

9. Low battery indication:

The low battery icon "
battery status. The batteries should be replaced.
10. Precautions
Use a pin to press the reset button (B1) if the Unit does not work properly.

Avoid placing the clock near interference sources/metal frames such as computer or TV sets.

The clock loses its time information when the battery is removed.

Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas

The outdoor sensor must not be set up and installed under water. Set it up away from direct

sunlight and Rain
Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning

agents may scratch plastic parts and corrode electronic circuits
If there is any inconsistency of weather forecast between Local Weather Station and this unit,

the Local Weather Station's forecast should prevail. The manufacturer will not take
responsible for incorrect forecasting from this unit.
" flash. Press "SNOOZE" button (B6) to activate
" flash on the LCD). The alarm will snooze for around 5
"will appear l indicating that thermo sensor is in low
" shown
8