Table of Contents
Advertisement
IDENTlFlCATlON PLATE LOCATlON
The tractor model and serial number identification
plate is located o n the left side of engine base assem-
bly below the engine. (Fig. 1)
Refer to engine manufacturers engine literature for
location of engine model and serial number
identification
Plate Location
FIG. 1
Spindles
. 7
Wheels
Tie Bar
Axle
Pivot
LT1013
FIG.
2
c . Spindles
-
one fitting o n both ends of front
axle. (Fig. 2)
d.
Axle Pivot
-
one fitting i n center of axle.
(Fig.2)
e
S t e e r ~ n g Gears
-
clean gear teeth on s t e e r ~ n g
gearand gearsector Apply grease liberally t o
all gear teeth (Fig 3 )
LUBRICATION AND
MAINTENANCE
LUBRICATION:
1 ENGINE
-
Check engine oil level before each
engine operation. Change englne oil every 25
operating hours (more often under dusty condi-
Lower
tions). Consult englne manufactureis servlce
Bearing
manual f o r a l l lubrication and malntenancespecl-
Capscrews
fications.
\
2 . GREASE
-
Every 2 5 operating hours grease the
following lubrication points with NLGl Grade 2
Lithium base EPgrease (Ford IT-MlC137-8). Re-
ference (Figs. 2 and
3).
NOTE: Clean off grease fittings before attaching
grease gun. Grease only until grease comes out
Steering Gears.
of bear~ngs. Wipe off excess grease Use a pres-
Apply Grease To
sure type grease gun
All Gear Teeth.
a.
Front Wheels
-
one fitting located on insides
L ~ I O I B
of each front wheel. (Fig. 2 )
FIG. 3
b.
Tie Bar
-
o n e fitting on both ends. (Fig.
2 )
2 Yard Tractor
Form No.
620-291
Rev.
11/85
Hide quick links:
Advertisement
Table of Contents
