Traction Drive Gear Shift Lever Adjustment (Ivlodel 09Gn2151 Only); Traction Drive Gear Shift Lever Adjustment - Ford YT 16 Manual

TRACTION DRIVE GEAR SHIFT LEVER
ADJUSTMENT: (Model 09GN2152 only)
Traction drive gear shift lever is factory set and
should not normally need adjustment. If at such time
thatsome gears cannot b e achieved orUNEUTRAL" is
not in the proper position, adjustment of the control
rod clevis may be necessary. T o perform this adjust-
ment, follow procedures below:
A
WARNING: T o avoid accidental starting, re-
move spark plug wires and secure away from
spark plugs.
A. Before this procedure is performed, the at-
tachment should b e removed from this trac-
tor as outlined in "ATTACHMENT" section of
this service manual.
B. Remove spring clip from top of gear select
lever. Detach speed control rod clevis from
gear select lever (Fig. 25A).
Speed Control
Rod
Lever
2.0038
FIG. 25A
C. Set gear shift lever in "NEUTRAL" position.
Manually set gear select lever in the "NEU-
TRAL" position.
D. Adjust speed control rod clevis until clevis
can be inserted onto pin o n top of gear select
lever.
E. Jack rear of tractor u p and rotate wheels
while checking engagement in NEUTRAL,
REVERSEand 5th gear, before running trac-
tor under power. Readjust if necessary.
Nyliner
Steer~ng And ldler
pport Bracket
Clutch
Pivot
Bracket.
\ :
Flat Washer
Flat Idler Pulley- -Belt Finger
Belt F ~ n g e r
Capscrew
Lockwasher-
Capscrew Fiat Washer
FIG. 26
TRACTION DRIVE GEAR SHIFT LEVER
ADJUSTMENT: (Model 09GN2151 only)
Traction drive gear shift lever is factory set and
should not normally need adjustment. If at such time
thatsomegears cannot beachieved or "NEUTRAL" is
not in the proper position. adjustment of the control
rod yoke end may be necessary. T o perform this
adjustment, follow procedures below:
A
WARNING: T o avoid accidental starting, re-
move spark plug wires and secure away from
spark plugs.
A. Before this procedure is performed, the at-
tachment should be removed from this trac-
t o r asoutlined in "ATTACHMENYsection of
this service manual.
B. Remove spring clip from clevis pin in yoke.
Remove clevis pin. (Fig. 25)
C. Set gear shift lever in "NEUTRAL" position.
Manually set transmission lever in the "NEU-
TRAL" position.
D. Adjust yokeend oncontrol rod until clevis pin
can be inserted through hole in bellcrank.
E. Jack rear of tractor up and rotate wheels
while checking engagement in NEUTRAL.
REVERSE and 5th gear, before running trac-
tor under power.
Form
No. 620-308
Rev. 1 1 I85
Yard Tractor 19