Table of Contents
Advertisement
Error Message
Please Empty Stacker
Please Check
Chip Box
Stacker Upper
Switch ??
3-12
Possible Cause
1. The Stacker is full.
2. The Stacker Tray
was left in the
DOWN position.
Each time the
FusionPunch II is
turned
this
message will appear. It
will also appear after
100,000 completed
punches.
The Stacker's Upper
Switch did not release
during an emptying
operation.
Figure 3-4: Punch-Generated Error Messages
Resolution
1. Press the appropriate
button (No. 1 or No.
2) to lower the Stacker
Tray. Then, unload the
Stacker.
2. Press the appropriate
button (No. 1 or No.
2) to raise the Tray to its
Home position. If the
problem persists, call your
GBC or Xerox Service
Representative.
Open the Punch Right Door,
and leave it open for at least
5 seconds before closing it.
The total count will not be
affected by opening the
Punch Right Door.
Lower and raise the Stacker
Tray several times, using the
appropriate
button (No. 1
or No. 2). Then, press the
button.
If the problem persists, call
your GBC or Xerox Service
Representative.
Troubleshooting
Advertisement
Table of Contents
