GBC 16 Series User Manual page 55

3
Open the Right Punch Door.
4
Use the Backgauge Adjustment Knob to correct the margin, as shown in
Figure 2-9. Adjust as follows:
To
n
the punched holes, turn the Backgauge Adjustment Knob
To
n
5
Turn the Backgauge Adjustment Knob one click at a time and check the
margin at each position. Use the Single Sheet Feeder to run test paper
through the Punch. To do this:
a)
Set up the FusionPunch II in the following modes and destination;
"
b)
Ensure that the Stacker Tray is in the TOP position. If it is not,
press the
once or twice until the Stacker moves up to its TOP position. The
Punch will not start with the Stacker Tray down.
c)
Press
d)
Into the Single Sheet Feeder, feed a sheet of paper of the size
required for the job.
e)
Press the
f)
Press the
lower the Stacker.
g)
Open the Stacker Door and remove the punched sheet of paper.
h)
Close the Stacker Door and press the
6
Repeat Steps 4 and 5 until the margin is correct.
Setting the Backgauge
the margin between the leading edge of the copy and
.
the margin, turn the adjustment knob
" (or
.
or button to raise the tray.
).
or button either
button.
or button to
.
2
2-13