Table of Contents
Advertisement
3
Click on the
below.
4
Verify that the profile for the Downstream device to be used is
For punching and stacking the 11" edge in the Xerox High Capacity
l
Stacker, ensure the
For punching and stacking the 8.5" edge, ensure the
l
profile is Enabled.
For all other applications, ensure the profile that associates with the
l
Downstream device to be run is Enabled.
(In the figure above is an example of a job being sent to a
go to step 8. If this profile is visible but not
in the Enabled column), highlight the profile and click
click
Starting a Job
Figure 2-19: On-line Finishers tab
.
profile is Enabled.
.) If this profile is not visible in this window,
.
tab. The window will display as shown
(green check-mark
On-line
Finishers
Tab
2
and then
2-21
Advertisement
Table of Contents
