Table of Contents
Advertisement
when opened, allows access to various adjustment knobs and to the Slug
(punched paper chaff) Bin, which must be emptied periodically.
that the margin between the leading edge of the paper and the punched holes
is correct.
that each sheet of paper maintains registration as it passes through the Die
Set to be punched.
three spring steel straps, that is used to tension the paper just before it enters
the Die Set. The Sheet Eject Strap assembly is hinged and can be opened to
clear paper jams.
located under the Sheet Eject Strap Assembly, to the right of the Infeed
Guide. The Side Guide is adjustable and is used in Setting the Side Guide,
described above.
- the finishing device that follows the FusionPunch II. The Stacker
receives the punched output from the FusionPunch II and stacks it on an
internal tray that will hold 2500 sheets of paper. When the Stacker Tray is
full, the operator removes the stacked documents and generally transfers
them to a separate area for offline binding.
Glossary
- the narrow door in the front of the Punch cabinet that,
- an adjustment procedure that is done to ensure
- an adjustment procedure that is done to ensure
- an assembly consisting of a steel rail and
- a small, contoured paper guide made of sheet metal and
G
G-7
Advertisement
Table of Contents
