GBC 16 Series User Manual page 50

9
If the holes are centered, go on to
are not centered, go on to
10
Open the Right Punch Door.
11
Loosen the Locking Wing Nut, as shown in Figure 2-6.
12
Use the Edge Guide Adjustment Knob to make small (1/8 to 1/4-turn)
adjustments, as shown in Figure 2-6. Test after each adjustment until
the punched hole sets are centered.
Locking Wing Nut
13
Tighten the Locking Wing Nut after you have completed the
adjustments.
2-8
to adjust the Punch.
Figure 2-6: Edge Guide Adjustment
If the holes
Edge Guide
Adjustment Knob
General Procedures