Warning Markings; Electrical Supply; Ventilation - Xerox Troy PocketPro 100 Operator's Manual

Warning markings

Electrical supply

Ventilation

Operator Guide
Please contact your Xerox representative for more information.
All warning instructions marked on or supplied with the product
should be followed.
This WARNING alerts users to areas of the product where there is
the possibility of personal damage.
This WARNING alerts users to areas of the product where there
are heated surfaces, which should not be touched.
This product shall be operated from the type of electrical supply
indicated on the product's data plate label. If you are not sure that
your electrical supply meets the requirements, please consult your
local power company for advice.
This product must be connected to a protective earth circuit. This
product is supplied with a plug that has a protective earth pin. This
plug will fit only into an earthed electrical outlet. This is a safety
feature. Always connect equipment to a properly grounded
electrical outlet. If in doubt, have the outlet checked by a qualified
electrician.
To disconnect all electrical power to the product, the disconnect
device is the power cord. Remove the plug from the electrical
outlet.
Slots and opening in the enclosure of the product are provided for
ventilation. Do not block or cover the ventilation vents, as this
could result in the product overheating.
This product should not be placed in a built-in installation unless
proper ventilation is provided, please contact your Xerox
representative for advice.
WARNING
Safety
vii