Managing The System; Starting, Stopping, And Rebooting The System; Powering On The Controller; Powering On The Printer - Xerox Troy PocketPro 100 Operator's Manual

Starting, stopping, and rebooting the system

Powering on the controller

Powering on the printer

Operator Guide

3 Managing the system

This chapter provides management-related information that
pertains to the system as a whole such as starting, stopping, and
rebooting the system and operating the tape drives.
Shut down and reboot the system only when you are directed in
the "Troubleshooting" chapter of this guide; or after loading new
software, such as Novell NetWare or AppleTalk gateways.
CAUTION: Do not shut down the controller using the Quit option
on the pull-down menu of any window or the Exit option on the
Workspace pop-up menu.
Wait at least one minute after power has been switched off before
continuing. Then switch on power to the controller components in
the following order:
1. Any external SCSI devices, starting with the unit with the SCSI
terminator and following the connection chain toward the Sun
workstation
2. Other peripherals
3. Monitor
4. Sun workstation
When the operating system finishes rebooting, the Xerox
application software starts. When the DocuSP Print Services
window displays, power on the printer.
1. Make sure the printer power cord is securely plugged into the
power receptacle, and the power button is pressed on.
2. Log on as the Administrator or Operator.
3. On the DocuSP Print Services window, select [Printer On]
from the Printer menu.
3-1