Xerox Troy PocketPro 100 Operator's Manual page 44

Overview
1- 2 8
1. Vents in front of processor
2. Vents in back of processor
Figure 1-20 Sun Blade 2500 and Sun W1100z common fan and vent
locations to keep clear
1. Vents in front of processor
2. Vents in back of processor
CAUTION: Do not place the monitor on top of the processor. Do
not block any fan or vent on the front, sides, or rear of the
processor.
Do not:
• Do not place the monitor and processor on a desk or table top.
• Do not place the monitor on top of the processor.
• Do not allow any piece of equipment to blow warm air into the
air intake vents of the processor.
• Do not place the processor on its side, or in any other position
but the upright, vertical position achieved by using the
controller stand.
• Do not place the processor or monitor on top of the printer.
Operator Guide