Xerox Troy PocketPro 100 Operator's Manual page 136

Troubleshooting
5- 3 4
To clean the feed belt:
1. Clear any misfeeds that have occurred, but do not relatch the
paper feeder assembly. The paper feeder assembly must be
unlatched to clean the belt; if necessary, unlatch it by pressing
down on the bright green lever on the right side of the paper
tray.
Figure 5-25 If necessary, unlatch paper feeder assembly
2. Lightly moisten a lint free towel with a Xerox recommended
film remover and wipe the outside surface of the feed belt
thoroughly in the same direction as the ribs on the belt. Wiping
from side to side might pull the belt off its track. Allow a few
seconds for the film remover to evaporate.
Operator Guide