Advertisement
Operation
Adjusting the Headlights
Using the top screws shown in Figure 21, adjust the
headlights per local standards.
1
Figure 21
1. Headlight adjusting screws
Operating the Lights
Position marker lights (front and rear)
Depress the top of the switch, the switch will be
illuminated and the red (rear) and white (front) marker
lights will come on.
Headlights
Rotate the ignition switch to position 2 to illuminate
the headlights.
Hazard lights
Depress the top of the hazard light switch, all four
indicator lamps will flash. The ignition switch does not
need to be on for these to operate.
Direction Indicators
With the ignition switch at position 2, depress the
relevant side of the direction indicator switch, the two
indicator lamps on that side of the machine will flash.
Brake Lights
The brake lights will automatically come on when the
machine is decelerating, i.e, when the control pedal
is returning to neutral, when travelling in a forward
direction only.
Maintenance
General Maintenance
Important: Replace all worn or damaged parts
with genuine Toro parts.
1. Check that all lights are working on a regular basis.
2. Ensure the headlights are adjusted correctly.
3. Clean the lights daily - avoid using solvent based
Replacing a bulb
1. Remove the lens cover.
2. Replace the bulb.
3. Replace the lens cover.
G018337
4. Adjust the lights. Refer to Adjusting the Headlights
11
products.
in the Operation Section.
Advertisement
