Toro 02917 Installation Instructions Manual page 10

7
Installing the Reflectors
Parts needed for this procedure:
2 Reflector
Procedure
Affix a reflector to each side of the engine cover.
Ensure that the outside edge of each reflector is adhered
100mm (4 inches) from each edge of the engine cover
(Figure 20). Make sure the surface is clean before
mounting the reflectors.
g018255
Figure 20
1. 100mm (4 inches)
8
Installing the Serial Label
Parts needed for this procedure:
1 Serial label
Procedure
Affix the serial label adjacent to the machine serial label.
Make sure the surface is clean before mounting the serial
label.
1
2
2. Reflector
10