Advertisement
1
2
1. Round blanking plug–horn
button
9. Install the horn decal lining up the edges of the
round and rectangular holes (Figure 18).
1
2
1. Horn button
2. Horn decal
10. Install the horn button and the direction indicator
switch into the control panel (Figure 18). Install the
direction indicator switch with the Green/Red wires
to the left and the Green/White wires to the right, as
shown in Figure 19.
G018336
Figure 17
2. Rectangular blanking
plug-indicator switch
3
G018335
Figure 18
3. Direction indicator switch
G018338
1. Green/Red
11. Connect the direction indicator switch to the
connector lead instrument panel. The indicator
connector is black and on the longer lead.
12. In the control panel there will be a pink and
black/purple wire for the Horn button. Connect the
pink and black wires to the horn switch.
13. Working under the operator platform, connect the
connector lead instrument panel to the multi pin
connector on the machine main electrical wiring
loom. This is located in the chassis rail to the right
of the transmission pump.
14. Cable tie all cables for the front lights, rear lights and
the pressure switch so that they are secure and to
prevent them from becoming trapped or chafed.
15. Reconnect the negative battery cable.
16. Test the switches on the control panel to ensure that
they are operating correctly.
17. Refit the control panel ensuring that no connectors
have become detached and that no cables are nipped.
18. Lower and latch the engine cover and operators
platform.
9
1
2
Figure 19
2. Green/White
Advertisement
