Advertisement
1. Blue
2. Green
3. Red/White
8. Repeat the above procedure for the L.H. light
assembly. Identify and mark this connector as L.H.
to help with cable identification when making the
connections to the machine main wiring loom.
9. The cables can now be connected to the main wiring
loom of the machine. Pass the cables down through
the cutout for the towing point and though the holes
in the front chassis to the cutting unit manifold
located under the operators platform.
10. Locate the two 4-pin connectors on the main wiring
loom located near to the cutter manifold.
11. Remove the blanking caps from the lighting
connectors on the main wiring loom.
12. Connect the connector on the machine wiring loom
with GREEN/WHITE wire to the identified L/H
light assembly connector. (Figure 13).
5
g018250
Figure 12
4. Black
5. PM4 connector
1
1
2
2
3
4
3
4
1. Blue
2. Green/White
3. Red/White
13. Secure the connector, on the machine wiring loom
with the GREEN/RED wire, to the identified R/H
light assembly connector (Figure 14).
1
2
3
4
1. Blue
2. Green/Red
3. Red/White
7
6
g018251
Figure 13
4. Black
5. Green
6. PM4 connector
6
g018252
Figure 14
4. Black
5. Green
6. PM4 connector
1
5
3
4
1
5
3
4
Advertisement
