1. Attention ■About this manual 1. Before using the camera, please read this manual thoroughly and use the camera properly. 2. Please keep this manual reachable and always refer to the contents when needed. 3. Please contact us if the manual is lost or damaged. We will provide a replacement. Our contact address is written in the end of this booklet.
Page 4
■For Safe Use Warning ●In following circumstances, please stop using the product and turn off the power immediately to prevent the risks of fires and electric shocks. If the product is defective, please contact us for repair or exchange. Our contact address is written in the end of this booklet.
Page 5
For more details, please refer to the following link: Hardware Warranty: http://www.artray.us/download/artray_warranty.pdf ●We do not guarantee the functions of this product or the descriptions on this manual to be completely adapted to the users’...
2. Introduction ARTCAM-XQE-WOM series are NIR cameras which adopt a 1280 x 1024/ 1280 x 720 sensor. The cameras have a high sensitive spectral response from 400 nm to 1100 nm. ARTCAM-XQE-WOM adopt USB2.0 interface, so image data can be delivered to PC directly without a capture board. Also, this camera is equipped with an on board memory which avoid data missing during transfer.
4. The Product 1) Camera 2) USB Cable Type A-B connector cable, 3m approx. 3) Viewer software/Device Driver CD <Options> 1) C Mount lens 2) 5m extension cable with USB2.0 repeater 5. Connect the Camera 5-1 How to connect a camera - 7 -...
6. Specifications 6-1 Camera Specifications ARTCAM-130XQE-WOM ARTCAM-092XQE-WOM Sensor Type CMOS Image Sensor Active Pixels 1280(H)×1024(V) 1280(H)×720(V) Total Pixels 1292(H)×1040(V) 1292(H)×736(V) Active Imager 12.8(H)×10.2(V)mm 7.17(H)×4.03(V)mm 1” 1/2” Size Scan Mode Progressive Scan 10(H)×10(V)μm 5.6(H)×5.6(V)μm Pixel Size Detected 400~1100nm Wavelength Shutter Type Rolling Shutter Frame Rate 27.7fps(8bit) / 14.2fps(12bit)
Page 9
6-3. Global gain Global gain can be configured with the standard viewer software or SDK. The formulas for the setting value and gain are as follows. Model formula Setting range:0 to 11 (x3 to x24) Setting value :between 0 and 6 -> Gain = value + 3 Setting value :between 7 and 11 ->...
Page 10
6-5. Trigger timing chart Number Item Time Photo-coupler Delay Above 1 micro second Reset Time 6 * 1H ※1H = (1280 + 1232) * 1PCLK ※1PCLK = 1/80000000[sec] = 0.0125[micro sec] Exposure Time Setting value of Exposure(Shutter speed) * 1H Frame Transfer The number of Row pixels * 1H Image Transfer...
What may cause the problem is that the regulation of the power lines becomes not enough, and so causes impudence mismatch on data signals. *For the recommended extension cable, please contact our sales department. (TEL: +81-3-3389-5488) ARTRAY CO., LTD. Obtained ISO 9001: 2015 2018/9/17 1-17-5 Kouenjikita, Suginami-ku, Tokyo 166-0002 Japan...
Need help?
Do you have a question about the ARTCAM-XQE Series and is the answer not in the manual?
Questions and answers