Siemens TM Timer DIDQ Commissioning Manual page 22

Configuring
3.2 SIMOTION SCOUT
Software preconditions
Please observe the following requirements:
● SIMOTION SCOUT from V4.4 HF6 and higher
● SIMATIC Step7 V5.5 SP4 or higher and installation of the corresponding HSP file, minimum
HSP240.V2.1
Note
Download source for the HSP:
http://support.automation.siemens.com/WW/view/de/23183356
support.automation.siemens.com/WW/view/en/23183356)
Instructions to install the HSP for STEP7 V5.x are provided under the following FAQ:
http://support.automation.siemens.com/WW/view/de/22374877
support.automation.siemens.com/WW/view/en/22374877)
The technology modules are integrated into the hardware configuration (HW Config) of the
SIMATIC STEP 7 engineering system and are assigned parameters there.
HW Config is used by SIMOTION SCOUT and SIMATIC STEP 7 to configure the hardware of
an automation project.
Irrespective of whether you work with SIMATIC STEP 7 or SIMOTION SCOUT, the
parameterization is always performed in HW Config.
22
Technology Modules TM Timer DIDQ for SIMOTION SCOUT and SIMOTION SCOUT TIA
(http://
(http://
Commissioning Manual, 01/2015