Table of Contents
Advertisement
With the PedalPro switched ON
If the PedalPro is already ON when the Pedalino is switched ON, the calibra-
tion process will take place as above. Please do not touch or press the pads
until the calibration process is complete.
Once calibration is complete, the ADES connection will be automatically
established and you will see the following:
000 Ø PurePhaser
The preset number and name indicate the preset that is currently loaded on
the PedalPro. At the same time, the display on the PedalPro will show:
Play:
0 0
0Ç
* ADES ON *
This indicates that the PedalPro can now be completely controlled using the
Pedalino, and that the controls on the PedalPro are DISABLED. This screen will
remain for as long as the PedalPro is controlled by the Pedalino Foot Control-
ler. You are now ready to go.
Expression Pedal
After connection with the PedalPro has been established, if there is no ex-
pression pedal attached to EXPR. PEDAL connector [18], the display will show:
000 Ø PurePhaser
If you have loaded a preset where one of the parameters can be controlled
by the expression pedal, the display of the Pedalino will look something like
this:
P
u
rePh
a er
s
008 Ø CryBaby Ö
The top line of the display shows the parameter currently controlled by the
expression pedal and its instantaneous value. In the example above, it's the
centre frequency of the PedalPro inductor filter F1. The centre frequency is
currently set at 1.1 kHz (see the special section
page 22, for more information).
The symbol
may be manually appended to the name of the preset to act
Ö
as a reminder that one of the parameters of that preset has been assigned
to an expression pedal.
7.3
TEMPORARILY DISCONNECTING PEDALINO
While using the Pedalino to control the PedalPro, all the controls on the
PedalPro are purposely deactivated.
However should you need to quickly access the PedalPro's controls (for
instance, to modify a preset), you can do so by simply pressing the ADES ON/
OFF switch [3].
The ADES connection will be interrupted, as indicated by the associated LED
turning off, and the PedalPro display will revert to normal operating mode.
The display of the Pedalino will now show the status of the unit as 'Discon-
nected', to remind you that the ADES connection with the PedalPro is no
longer active. You can also disconnect from the PedalPro
Exit. To re-establish the ADES connection and use the Pedalino again to con-
trol the PedalPro, just press the ADES ON/OFF switch [3] and the correspond-
ing LED will light up.
9
Setup Guide
Wah=10
0.0
'ADES - An In-depth
Disconnected
by using the key
Look' on
7
Rev. 2.0 - EN EU - fw 4.22
Advertisement
Table of Contents
