Table of Contents
Advertisement
How to Use Your Pedalino
8.6.2 Using Tap Tempo
Tap Tempo allows you to set the tempo to one or all the time-based effects
(modulation and delay) by using an Expression Pedal according to the defini-
tion of the Assign parameter (See page 50 of the PedalPro's manual).
Assign Expression pedal to the Tap Tempo
If you are in Browsing or Favourite mode press the BYPASS/MUTE pad [13]
•
to LEVEL 1 to enter in the Bypass Mode or press the BYPASS/MUTE pad [13]
to LEVEL 3 if you are in the Virtual Board Mode.
Setting Tap Tempo
•
Rock the expression pedal to toe position four times and the PedalPro
will average the four beats into the new Tempo. If the averaged Tempo
is within the range 60BPM to 300 BPM, the LED's Tempo will flash at the set
Tempo.
•
Your Tap Tempo is now switched On and you will notice that the LED's
Tempo above the Pedalino's display starts to blink at the same tempo
you tapped in.
•
Remove the Bypass to play with your new Tap tempo setting by pressing
the BY-PASS/MUTE pad [13] to LEVEL 1.
Resetting the Tap Tempo
•
Assign the Expression pedal to the Tap Tempo as described above.
•
Sweep your Expression pedal from heel to toe position and hold for
about 2 seconds. You notice that the LED's Tempo will stop blinking. As re-
sult the Tap Tempo is reset to the tempo as originally stored in the preset.
•
Press the BYPASS/MUTE pad [13] to LEVEL 1 to return at your Preset if you
8
are in Browsing or Favorite mode.
Rev. 2.0 - EN EU - fw 4.22
TIPS & TRICKS - TAP TEMPO
•
You can also control your Tap Tempo on the fly without entering in the
Bypass Mode as long as your Preset is not using the expression pedal
to control an Expression parameter (ExprCtrl=none from the PedalPro's
ADES page 48 of the PedalPro's manual).
•
Your Pedalino's display may appear like the one below and the top
line (Tap->Ex.pedal) confirms that your Tap Tempo is ready to be used:
TAP-ØEx. pedal
011ØChrs CE1
Keep in mind that the Tap Tempo operates in a range between 60
to 300 BPM for the modulation effects and between 98 to 300 BPM
for the Delay. If you tap in a lower tempo than 98 but above 60 BPM,
your Delay's Tempo will be set automatically to 98 BPM. As result
your LED's Tempo and your Delay's Tempo will be out of sync to
each other.
20
[
]
Tempo
Advertisement
Table of Contents
