Table of Contents
Advertisement
Getting to Know - Top Panel
1. BYPASS LED - When lit, the PedalPro is in full bypass mode.
2. MUTE/TUNER LED - When lit, it indicates that the PedalPro is muted AND
the tuner in PedalPro is activated. The tuning information is also shown on the
Pedalino's display.
3. ADES ON/OFF (switch & LED) - Use this switch to suspend and reactivate
the ADES connection with the PedalPro. When the LED is on, the ADES con-
nection is present. A blinking LED indicates that the connection is not present.
6
4. FAVOURITES (switch & LED) - Use this switch to access the favourite preset
list on your PedalPro. When the LED is on, the favourite preset list is loaded on
the PedalPro.
5. Display - Shows presets' names, effects' parameters, settings and other info.
6. TEMPO LED - It blinks to show the speed of the effects of the PedalPro*.
7. Force Feedback LEDs - Provide clear feedback on the level of force ap-
Rev. 2.0 - EN EU - fw 4.22
1
2
3
13
4
5
6
7
8
CryClass=11
00 Hz
008 Ø CryBabyWdÖ
14
15
plied on the sensor pads 13-16. Three levels of force (LEVEL 1, LEVEL 2 and
LEVEL 3) are possible, as indicated by the number of LEDs lit up.
8-12. –, +, MENU, SET & EXIT keys - Use these keys to navigate through the
menus of the Pedalino and change its settings.
13. BYPASS/MUTE pad - Press to LEVEL 1 to completely bypass the PedalPro.
Press to LEVEL 3 to soft mute PedalPro - e.g., for changing guitars - and to
activate the tuner. Tuner information is visible on display 5.
–
14.
pad - In browse mode, press to LEVEL 1 to decrease preset number by
1. Press to LEVEL 2 to decrease it by 10, press to LEVEL 3 to decrease it by 50.
In favourite mode, please refer to
15. Load pad - In browse mode, press to load the new preset.
+
16.
pad - In browse mode, press to LEVEL 1 to increase preset number by
1. Press to LEVEL 2 to increase it by 10, press to LEVEL 3 to increase it by 50. In
favourite mode, please refer to
6
9
10
11
12
16
section
8.3, on page 11.
section
8.3, on page 11.
Advertisement
Table of Contents
