Table of Contents
Advertisement
Examples: 3-levels favourite access mode
When your Pedalino is set to work in 3-levels mode and bank A is selected,
−
by pressing pad
[14] to LEVEL 1, favourite preset 01 will be loaded, like in
the prevoius example. The display of your Pedalino will show:
01 Ø VarymuC p m
. A
Once again, the letter
A
indicates the selected favourite bank.
If you now press on LOAD pad [15] to LEVEL 3, favourite preset 08 will be
loaded (see
Table
I) and the display will show:
08 Ø SustComp
. A
With the favourite preset bank switched to bank B, by pressing pad
LEVEL 1, favourite preset 10 will be loaded and available to play. The display
of your Pedalino will show:
. B
10ØTubeDist
+
By pressing on pad
[16] to LEVEL 3, favourite preset 18 will now be loaded,
and the display will show:
. B
18ØDelayAtt
8.4 VIRTUAL BOARD MODE
The virtual board mode transforms your Pedalino into a pedal board allowing
the user to switch on/off effects or group of effects, to assign specific function
of the expression pedal and to send midi program changes.
There are four editable virtual boards (Rock, Blus, Fusn and Funk) which oper-
ates globally on the different presets.
Each preset is assigned to one the four available virtual boards from the
PedalPro. The virtual board Rock is assigned by default to all presets. To
o
change the virtual board type (refer to section 10.2.3, PedalPro's user
manual).
Entering in virtual board mode:
•
From a loaded preset either in browsing or favourite modes press and hold
the BYPASS/MUTE pad [13] to LEVEL 2 for about 2 seconds.
The display will temporarily (1 sec.) visualize the virtual board name and than
the full preset layout.
If the preset has the Compressor and Delay on, the display will point out as
following:
−
[14] to
8.4.1 Assigning effect to a pad of the virtual board
At the first pressure level of the virtual board mode, the Pedalino's four pads
are used to activate and deactivate individual effects or group of effects.
•
To assign an effect or a grouped of effects to a pad, press Menu Key (10)
1
to enter in the assign page. The display shows on the top line the selected
virtual board (eg. Rock) while the bottom line shows the pad you wish to
assign. The pad are numbered from left to right. Therefore the Pad=1 cor-
respond to the Pad Bypass/Mute while the Pad=4 correspond to Pad+
•
To select a different Pad use the + Key (8) and the - Key (9).
Ö
13
How to Use Your Pedalino
.
. . . . . . . . . . . . .
Cp
. . . . . . . . . . .
Dl
Define VB=Rock
Assign PAD=2 _
. . .
8
Rev. 2.0 - EN EU - fw 4.22
Advertisement
Table of Contents
