Table of Contents
Advertisement
How to Use Your Pedalino
8.10 TEMPORARILY DISCONNECTING PEDALINO
While using the Pedalino to control the PedalPro, all the controls on the
PedalPro are purposely deactivated.
However should you need to quickly access the PedalPro's controls (for
instance, to modify a preset), you can do so by simply pressing the ADES ON/
OFF switch [3].
The ADES connection will be interrupted, as indicated by the associated LED
turning off, and the PedalPro display will revert to normal operating mode.
The display of the Pedalino will now show the status of the unit as 'Discon-
nected', to remind you that the ADES connection with the PedalPro is no
longer active.
To re-establish the ADES connection and use the Pedalino again to control
the PedalPro, just press the ADES ON/OFF switch [3] and the corresponding
LED will light up.
8
8.11 CHANGING AND CUSTOMISING THRESHOLDS
Pedalino comes with two factory-defined sets of thresholds (global thresh-
olds) which determine the degree of force that must be applied to each
control pad in order to reach the three levels that control the various func-
tions (see
section
8.1). The two factory-defined sets are 'soft' and 'hard'.
The 'soft' set requires the least amount of force to reach the different levels,
Rev. 1.1 - EN EU - fw 4.10
Disconnected
as indicated by the LEDs, and is designed for those who want more sensitive
pads, or for use when playing sitting. The 'hard' set requires the most force,
and is designed for people who prefer less sensitive pads, or for use when
playing in a standing position.
If you want more control over the responsiveness of your Pedalino, you can
customise the sets of thresholds to better suit the amount force you want to
apply. You can do this either by adjusting the global threshold sets and thus
the thresholds of all four pads at once, or adjusting individual pad thresholds.
8.11.1 Switching between the predefined thresholds
The first time you turn on the Pedalino, the 'soft' set will be loaded.
•
To switch the threshold configuration from 'soft' to 'hard' and vice versa,
press the MENU key [10] until the top line of the display reads 'Pad Prefer-
ence'
P
ad pr efer enc
•
Press the SET key [11] to enter the 'Pad preference' menu. Page 1 of 3 of
the menu shows the set of thresholds currently in use, in this case, 'soft'.
Force=soft
•
Use the + key [8] and the – key [9] to switch between the 'soft' and
'hard' predefined thresholds.
F
or e=har
c
20
e
1
/3
-
d
1
/
3
_
Advertisement
Table of Contents
