Table of Contents
Advertisement
Type – This parameter allows you to assign to the Preset you are editing, one of
the four Virtual Board: Rock, Blus, Fusn, Funk.
To change the Type parameter, press EDIT [5]. Select the Virtual Board with the
selection dial [4].
•
After selecting the Virtual Board, exit the ADES configuration page by
pressing EXIT [7] and Save the Preset.
8.7
ADJUSTING PEDALPRO'S EFFECTS ON-THE-FLY
Pedalino allows you to change several key parameters of your PedalPro's
effects direct from the Pedalino. This enables you to fine-tune and adjust your
sound on-the-fly when performing live, to match the type of gig or venue you
are playing, without having to disconnect your PedalPro.
The following parameters are directly accessible:
1 - EmphVolm
- Emphasis volume
2 - DistDiod
- Dist. diode level
3 - DistJfet
- Dist. Jfet level
4 - DistFuzz
- Dist. Level
5 - BoostGain
- Preamp boost gain
6 - CompSens
- Comp. sensitivity
7 - CompOut
- Comp out level
8 - Aux_Wet
- Aux/Dsp wet
9 - Dly_Fback
- Delay feedback
10 - Delay_Out
- Delay out level
11 - TremDepth
- VCA depth
These parameters can be adjusted in real-time. Any change can be imme-
diately stored within the preset and will be available next time you load that
preset (see section below: Protecting PedalPro's presets).
You cannot modify PedalPro's effect chain from your Pedalino.
8.7.1 Adjusting parameters on-the-fly
To adjust one of the parameters listed above, press the SET key [11] while
•
the Pedalino is in browse mode or in favourite mode or in virtual board
mode and the
ADES connection
will now look like this:
EmphVolm:022.7
DistDiod:034.1
You now have access to the Emphasis Volume and the current value is set at
22.7.
23
How to Use Your Pedalino
12 - ChorusWet
- Chorus Wet
13 - FlngRegen
- Flanger Regen
14 - FlangeWet
- Flanger Wet
with your PedalPro is active. The display
8
Rev. 2.0 - EN EU - fw 4.22
Advertisement
Table of Contents
