Table of Contents
Advertisement
When you are using the tuner, the ADES ON/OFF switch [3] is deacti-
vated and you cannot interrupt the ADES connection with the Pedal-
Pro.
8.5.4 Switching banks in favourite mode
In favourite mode the control pad at Level 2 is used to switch among banks.
For more information on this matter refer to chapter 8.3 page 11.
8.5.5 Enter and exit Virtual board
To enter or exit the virtual board mode press and hold the control pad at the
Level 2 for more than 2 sec.
8.6 FUNCTIONS OF THE EXPRESSION PEDAL
The expression Pedal can be used either to control an analogue parameter
or to set the Tap Tempo.
8.6.1 Using an Expression Pedal
Pedalino allows you to control in real-time a number of the parameters of
the analogue effects on your PedalPro using an expression pedal. The table
below gives you a list of compatible models.
Plug the expression pedal into the EXPR. PEDAL connector [18] at the
•
back of the Pedalino using a standard stereo patch cable. The EXP.
MODE switch [19] must be set according to the
A
at the end of this manual (page 33) if the expression pedal is to work
correctly. You may need to use a pen, screwdriver or similar tool to set
the EXP. MODE switch [19] (it is recessed by design to prevent accidental
switching).
•
Now assign to the expression pedal the parameter you wish to control.
You must do this via the ADES menu page on the PedalPro. Please refer
to the PedalPro Owner's Manual for details on how to do this.
•
Load the preset using your Pedalino and following the steps detailed in
sections
8.1
and 8.2. The display of the Pedalino will now look like this:
The top line of the display indicates the name of the parameter that you can
control in real-time, and its current value.
Using the expression pedal, you can now sweep in real-time through the
predefined range* of that parameter. For extra information on the list of
available parameters that you can control in real-time, and their predefined
ranges, see the section below:
Please check the table in
shows the correct position of EXP. MODE switch [19] when using some of the
most popular expression pedals on the market. If your expression pedal is not
shown in the table, you may have to experiment with the position of EXP.
MODE switch [19] in order to find the appropriate setting.
table shown in Appendix
19
How to Use Your Pedalino
Wah=10
008 Ø CryBaby Ö
'ADES - An In-Depth
Appendix A
at the end of this manual. The table
The PedalPro is disabled when the ADES connection between the
PedalPro and Pedalino is active. If you want to create or modify the
assignment to your expression pedal of an effect's parameter, you
must first temporarily disconnect the two units using the ADES ON/
OFF switch (3). Once you have made your modifications, save the
preset. Now press the ADES ON/OFF switch again to reconnect the
Pedalino to the PedalPro, and try out your new expression param-
eter setup.
0.0
Look'.
Rev. 2.0 - EN EU - fw 4.22
8
Advertisement
Table of Contents
