Table of Contents
Advertisement
How to Use Your Pedalino
8.8.6 Protecting PedalPro's presets (temporary adjustments)
If you do not want your on-the-fly changes permanently stored in the Pedal-
Pro's preset (say, you are only testing some adjustments to one of your stored
sounds), you can protect PedalPro's presets from changes using preset save
protection.
With the Pedalino in browse mode, press MENU key (10) until the top line
•
of the display reads 'Save preference':
S
av pr efer enc
Press the SET key [11] to access the configuration page.
•
Pr otec t=Of
When preset save protection is switched OFF, changes you make using your
Pedalino are immediately stored within the active preset in your PedalPro
and will be available next time you load that preset.
•
To toggle Pedalino's preset save protection ON or OFF, use the + key [8]
or the – key [9].
8
Pr otec t=On
When preset save protection is switched ON, on-the-fly adjustments made to
a preset using your Pedalino are NOT stored within the active preset in your
PedalPro and they will be lost as soon as you load a different preset stored in
your PedalPro.
Rev. 2.0 - EN EU - fw 4.22
e
e
f
/1 1
/1 1
8.8.7 RE-INITIALISING THE PEDALINO
If you want to restore Pedalino's factory settings and reload the factory value
for user-defined thresholds, you can do that by re-initialising your Pedalino
Foot Controller.
In browse mode or in favourite mode press the MENU key [10] until the
•
top line of the display reads 'Initialise'.
I t
ni i al ise
Now press the SET key [11]. You will be asked to confirm the action by
•
pressing the SET key [11] again.
Sur e? Set=yes
Press the SET key [11] to confirm or the EXIT key [12], if you want to can-
•
cel the action.
28
Advertisement
Table of Contents
