2.6.2 Logging; Figure 2.9 Set-Up Logging Menu; Table 2.4 Logging Parameter Set Up - Kahn HygroPort I.S. User Manual

HygroPort I.S. User's Manual

2.6.2 Logging

LOGGING
Highlight
using a combination of the  (up) and 
(down) keys and press the Enter key. The
Logging Set-up menu, is then displayed, see
Figure 2.9.
FILE NAME
Initially the
f i ield is used to def i ne a name for a new log file
and can be any combination of Alphanumeric
characters (max 8 digits). NOTE: If a file
name is not entered, a logging cycle
cannot be started.
To enter the parameter value f i ield press the
Enter key. A prompt (-) for the first character
is then highlighted. Use a combination of the
scroll up and scroll down keys to insert the first
character and then the scroll right key to shift to
the second character position.
Repeat the above procedure until all characters
have been entered and press the Enter key.
PARAMETER
Set up the
LOG INTERVAL
in a similar manner.
After setting up the logging parameters, start the log cycle by selecting
the Enter key to highlight
STARTED
field value to
Table 2.4 details the field values. To quit, press the scroll left key.
Parameter
FILE NAME
PARAMETER
LOG
INTERVAL
START ?
Issue 6, December 2019
from the Main Menu by
f i ield is highlighted. This
to be logged and the
STOPPED
and use the scroll down key to change the
. Press the Enter key to start the logging cycle.
Parameter variable options
Defines datalog file name. Field width up to eight alpha- numeric
characters. Set with the scroll up, scroll down, scroll right and
scroll left keys (NOTE: Scroll left  deletes characters)
Sets parameter to be logged. This need not necessarily be the
same as that displayed on the Main Display. Options available,
DEWP, GM 3 , GKG, RH, PPMW, PPMV, CALC DP
Sets Log Interval in 5 sec increments. Range 5 to 600 seconds
Controls datalog Start and Stop functions. Logging cannot be
started if a file name has not been defined. Once started, log file
parameter f i elds are locked out and cannot be changed.
Table 2.4 Logging parameter set up
15
FILE NAME -
PARAMETER DEWP
LOG INTERVAL 5
START? STOPPED
FILE NAME -
PARAMETER DEWP
LOG INTERVAL 5
START? STOPPED
FILE NAME N2A-
PARAMETER DEWP
LOG INTERVAL 5
START? STOPPED
FILE NAME N2A
PARAMETER DEWP
LOG INTERVAL 5
START? STOPPED
Figure 2.9 Set-up Logging menu
Kahn Instruments
>
LOGGING
s
>
LOGGING
s
>
LOGGING
s
>
LOGGING
Sec
START?
. Press