Table of Contents
Advertisement
HygroPort I.S. User's Manual
4.4.2 Display Current Datalog File
To display the current log file, while the instrument is logging, press the (right) key
when the chart is displayed. A typical log file is shown in
The current page of the log file is shown. Log files start at 1. To view log plots earlier
or later than the currently displayed page use the scroll up and scroll down keys.
To return to the chart, press the scroll left key. Section 2.6.9 gives further details.
4.5
Logging
Logging can be set up either from the Logging Menu or from the Chart option (see
Section 4.4.1). Both methods of entry lead to the same set-up menu as shown in
Figure 4.6
.
To set up a log file the general procedure is as follows (Section 2.6.2 details the full
procedure):
1.
Enter a file name.
2.
Enter the name of the parameter that requires logging. NOTE: This
need not necessarily be the same as that in the primary display
(or chart)
3.
Enter the log interval (5 to 600 seconds in 5 second increments).
4.
Start the log file by entering the
scroll down key, and pressing the Enter key.
After the log file has been started, quit the
and return to a required previous screen, e.g. pressing three times returns to the Main
menu with the Logging display icon in the status line.
Issue 6, December 2019
#
INT
EXT
ST
106 26.8
-100.0 0028
107 26.2
-90.0 0028
108 25.9
-80.0 0028
109
25.8
-70.0 0028
110
25.5
-60.0 0028
Figure 4.5
Typical log file display
FILE NAME
-
PARAMETER
DEWP
LOG INTERVAL
5
START?
STOPPED
Figure 4.6
Logging set-up menu
LOGGING
36
Figure 4.5
.
File
CR270309
INT
RH
EXT.
EXT_DP
INTVAL
05 Sec
D#
090327
T#
123606
>
LOGGING
s
START?
field, selecting
STARTED
option by pressing the scroll left key
Kahn Instruments
with the
Advertisement
Table of Contents
