Installing The Cfp-21Xx Controller On A Compact Fieldpoint Backplane - National Instruments Compact FieldPoint cFP-21 Series User Manual

Chapter 2 Installing Compact FieldPoint Hardware and Software
Caution Disconnect power before removing the backplane from the DIN rail.
Installing the cFP-21xx Controller
on a Compact FieldPoint Backplane
cFP-21xx and cFP-BP-x User Manual
1 DIN Rail Clip
Figure 2-12. One Edge of DIN Rail Inserted in Clip
3. Press down firmly on the backplane to compress the spring until the
clip locks in place on the DIN rail.
4. Connect the safety ground as explained in the
Safety Information
Make sure that no power is connected to the controller or the backplane.
Refer to Figure 2-13 and follow these steps:
1. Make sure that the cFP-21xx controller is right side up, with the NI
logo at the top, and align the captive screws on the controller with the
holes on the backplane.
2. Seat the card edge at the back of the controller in the card-edge
connector on the backplane.
3. Press the controller firmly to seat it on the backplane.
4. Using a number 2 Phillips screwdriver with a shank of at least 64 mm
(2.5 in.) length, tighten the captive screws to 1.1 N ⋅ m (10 lb ⋅ in.) of
torque. The nylon coating on the screws prevents them from loosening.
1
2 DIN Rail Clip Spring
section.
2-12
2
3
3 DIN Rail
Compact FieldPoint
ni.com