Configuring The Xc Series - Xantrex XC1524 Owner's Manual

Configuring the XC Series

Once the charger is connected to a battery on bank 1 or to AC, it is live and it may
be configured. There will be a short delay of about 15 seconds before the remote
display begins reporting. The remote display will use this time to query the charger
for the current operating conditions.
If AC was already applied, ensure that the charger is in on by pressing
if necessary.
To configure the battery bank type:
1. Press and hold
2. Press
The XC Series will default to Bank 1 and will show the present battery type
setting.
3. Press
indicator light will illuminate to show which bank has been selected.
4. Press
selected a battery type that is different from the present configuration, the bank
indicator light flashes.
Set the
If your battery is
Flooded Lead Acid (has removable caps intended for refilling)
GEL (any sealed type except AGM)
Absorbed Glass Mat (AGM)
Lead Calcium
Custom (if pre-configured at factory)
5. Press and hold
type. If n o is displayed, verify that you are setting the correct battery type and
try again.
6. Repeat steps 1 through 4 for all banks attached to the XC Series. Each time y e s
is displayed for a newly programmed battery type, the charger exits the
programming mode.
7. At any time during setup, you can press
change and return to charging or battery monitoring.
975-0187-01-01
until s e t (setup) is displayed.
MODE
to select the battery type configuration programming mode.
TYPE
repeatedly to select which bank you are setting up. The bank
BANK
repeatedly to select the battery type for each bank. When you have
TYPE
according to the table below:
TYPE
/
ON STANDBY
until y e s is displayed to store the selected battery
/
ON STANDBY
Configuring the XC Series
/
ON STANDBY
then select
F L a
G E L
A G M
L d C
C U S
once to cancel the current
2–15