Operating The Application - Siemens SIMATIC S5 Manual

2 Engineering
2.10

Operating the Application

The following chapter describes the operation as well as the test and diagnostic
functions of the different scenarios.
Prerequisites
The SIMATIC S5-CPU program and the CP1430 TCP connection configuration
include all example scenarios. The required S5 program blocks and the
corresponding functions are enabled via enable bits after loading the S5 program.
For successfully testing a scenario,
•
the corresponding enable bit in the SIMATIC S5-CPU must be set,
•
the corresponding SIMATIC S7-1500 station must be loaded,
•
the corresponding enable bit in the SIMATIC S7-CPU must be set where
necessary.
Table 2-28
Scen.
1
2a
2b
3
4a
4b
5
Ethernet Communication (ISO on TCP) between SIMATIC S5 and
SIMATIC S7-1500 Controllers
Entry-ID: 109482475, V1.2,
S5-CPU S7-CPU
enable bit Enable bit
M 130.5 -
M 130.3 E 0.1
M 130.4 E 0.2
M 130.2 E 0.1
M 130.0 E 0.1
M 130.1
E 0.2
M 130.6 E 0.1
07/2019
S7 station name
PLC_Sz1_F-W_S5- Communication via FETCH/WRITE
CP1430TCP and CP1543-1
PLC_Sz2_S- Communication via programmed
R_CPU_ID5_ID105 Open User Communication (single
instruction) and internal CPU interface
Communication via parameterized
Open User Communication (single
instruction) and internal CPU interface
PLC_Sz3_S- Communication via programmed
R_CP_TRCV_C_ID7 Open User Communication (compact
instruction) and CP1543-1
PLC_Sz4_S- Communication via programmed
R_CP_ID4_ID104 Open User Communication (single
instructions) and CP1543-1
Communication via parameterized
Open User Communication (single
instructions) and CP1543-1
PLC_Sz5_S- Communication via programmed
R_CPU_TSEND_C_I Open User Communication (compact
D6 instruction) and internal CPU interface
Description
91