Adjusting/Replacing; The V-Belt - Woodstock M1109 Owner's Manual

M1109 Combo Lathe/Mill
For daily lubrication, use a manual oil gun with a general
10W machine oil to lubricate the following 15 ball oiler fit-
tings. See Figure 56 for some typical locations. Wipe off
all oil ball fittings with a rag, and then oil the following
locations:
• Cross Feed Table (1 ball oiler on top)
• Cross Feed Handwheel (1 ball oiler on top)
• Saddle Ways (2 ball oilers on top)
• Apron Handwheel Gear Axle (1 ball oiler on apron face)
• Compound Rest (1 ball oiler on top)
• Tailstock Barrel (1 ball oiler on top)
• Tailstock Handwheel (1 ball oiler on right side)
• Lead Screw Endcap Bushing (1 ball oiler, see Figure 57)
• Change Gear Spindle (1 ball oiler on end of shaft)
• Gear Spindle Ball Oiler (1 ball oiler, see Figure 55)
• Gearbox (4 ball oilers on top)
NOTICE
Failure to follow lubrication guidelines will lead
to rapid deterioration of lathe/mill components.
Figure 56. Typical ball fitting locations.
Figure 57. Lead screw end cap bushing.
-35-