Trigger Height Adjustment - Graco Gun Flush Box 244105 Instructions-Parts List Manual

Trigger Height Adjustment

Follow this procedure to ensure the gun triggers prop-
erly during a purge.
1. Insert the gun into the Gun Flush Box.
2. Remove the four screws that hold the cover (K) to
the Gun Flush Box. See Fig. 7.
3. Force the cylinder triggers on by connecting air to
port C (J). See Fig. 7. Turn on the air to extend
both cylinders.
4. Loosen both screws (L) on the side of the box that
hold the cylinder block (M). See Fig. 8.
J
Fig. 7
10 309227
K
5. Raise the cylinder (M) until the pin (N) opens the
trigger fully. See Fig. 8.
6. Tighten both screws (L) at the desired location for
the cylinder block (M).
L
M
Fig. 8
N