Table of Contents
Advertisement
16.3)
FIELD CONNECTIONS AND WIRING DIAGRAMS – SINGLE STAGE
The figure below shows the internal connection to operate the heater turning on and off 230V power to the heater.
Important: To operate the heater as single stage a jumper wire must be installed across the LO and HI terminals as
shown below. The heater will not operate with only 230V power to the HI terminal.
A. ON / OFF SWITCH CONNECTION - SINGLE HEATERS
To operate the heater with an individual thermostat use the same connections as above for the switch.
B. ON / OFF SWITCH CONNECTION - MULTIPLE HEATERS
Form 44201360
Oct 2019
33
Advertisement
Table of Contents
Need help?
Do you have a question about the COLD BLOCKER WB10CE-N7 and is the answer not in the manual?