Assembling The Torque Wrench; Fitting The Square Adapter On The Measuring Head - HBM TTS Mounting Instructions

TTS
During operation, the prevailing safety regulations for the security of person-
nel must be observed.
4

Assembling the torque wrench

The transfer torque wrench is taken apart and delivered in a carrying case.
The measuring head, the square adapter, the knurled screw, the lever and the
connecting cable are all separate. Depending on the nominal (rated) torque,
there are one, two or three parts to the lever.
CAUTION
If you want to use a different square adapter from the accessories pro-
gram, instead of the one supplied, you must keep to its maximum per-
missible torque (see Section 8, Page 36).

4.1 Fitting the square adapter on the measuring head

NOTE
We recommend that the square adapter is always installed in the same
angular position. The later transfer torque wrenches have arrows on the
measuring head and on the square adapter for ease of positioning (see
Fig. 4.8). The points of the arrows should point to one another.
A1571-1.2 de/en
27
HBM